1991 Nissan Truck E 2dr xtended Cab SB for sale in Cleveland, OH
Listed at $5,500 USD.
Price is firm. I have quite a bit more into the truck than I am asking. 7.3L IDI, 5 speed, 2 speed rear axle. High GVWR, just under CDL. I don't believe the 2 speed axle is hooked up.... a lot of times people will unhook them because they don't understand how to use them. This truck is mechanically injected, and will readily run on used motor oil cut down with some gasoline (it will run on 100% WMO but starting is harder and it smokes more). Motor is out of a lower mile school bus. Frame and bed are in great shape for the age. There is some pitting on the frame under where the box tubing & wood is at the front of the bed, personally I would plate the top of the frame there. I have some frame cutoff you can have. Cab needs repair to the floor and support rails. I have a open signed Michigan title. If transferring this to Ohio, it needs a VIN inspection. The truck needs some work before it can be driven out. I'm done working on it. Expect to spend a couple days on it if you have true mechanical abilities, including time to go through and check everything. I have air lines here you can use, bring your own tools. I WILL NOT do the work for you. I came into some money and bought a newer rollback. At a minimum this needs the 2 brake lines on the rear axle made up, and the brakes bled out (I replaced all of the other hard lines, and the rubber lines to the calipers). It needs the light wiring repaired, and the LR light re mounted. It needs the other 2 rear tires mounted, preferably on better wheels. Truck has new batteries, new Beru glow plugs, new GP controller, new long life diesel coolant, new thermostat, new belts, all new hydraulic hoses except for the return line and the winch lines, new hydraulic valve body. Everything in the front brakes is new - pads, calipers, rotors, seals and oil bath hubs. Drive shaft has been completely rebuilt - U joints, carrier bearings, slip joint seal, shaft painted. Parking brake works. There are 2 J hook chains and a bridle that I got with the truck that go with. You will need some straps also. I have not hooked up the winch and frankly the cable is ancient. It all needs gone through. Wheel lift will need one grid made or replaced (I need it for my other truck), and new L arms made or replaced. Or if you are going to just haul scrap, weld a couple of grab hooks to the Tee bar. I know the fuel gauge does not work, I think the temp gauge doesn't work. Truck seems to run good. I believe the glow plug wiring has a short, or a bad connection. The power wire in gets very hot. I unhooked the relay. Truck will need to be started cold with starting fluid until this is fixed. Truck has 290k on the odometer. I bought the truck with a replacement motor from a bus partially installed, I towed it back from Michigan. No idea of the mileage on the bus motor. I know the wiper motor does not work, I have a junk cab with a motor that should work. The oil in the trans and rear axle should be checked. I do have the front bumper - the guy I bought it from took it off to do the motor swap. Just need 4 bolts & nuts. I have a video of the truck running and bed operating. I have thousands more into this than my price. Don't waste my time or your by offering whatever amount of money you happen to have.
- Price
- $5,500 USD
- Mileage
- 290,000 miles
- Fuel
- diesel
- Transmission
- manual
- Drivetrain
- rwd
- Body type
- Truck
- Condition
- fair
Photos
Buy directly from the owner on Carsido Marketplace. Listing located in Cleveland, OH.




















