1995 Volvo 960 Base 4dr Sedan for sale in Charlotte, NC
Listed at $500 USD.
PLEASE NOTE: the car is located in Winston-Salem. I'm posting in Charlotte in hopes of reaching a wider audience. Meet "Peabody," my stalwart daily driver for the last ten years. Currently, it cranks but won't run. Here's the story: For a year or so, it would sometimes idle rough upon starting for a few moments, then settle and run perfectly. A couple months ago, the misfire didn't correct itself. I limped the car home running poorly. Took it to the shop. They removed the ignition coil connector housings, cleaned the contacts, and the car ran perfectly - for about twenty minutes. On the way home from the shop, it started missing again. I returned it to the shop and they had another look. I'll quote their invoice directly. "Finding: confirmed the cylinder 5 ignition coil is not getting power. Tested the resistance between the cylinder between the ignition coil and the Motronic 1 Power Stage and found that the resistance is bouncing all over the place. Normally would suggest to run an overlay harness between the power stage and the ignition coil, but based on the condition of the rest of the visible harness and connectors, recommend replacing the engine wiring harness with either one in better condition, or to see if there are any aftermarket ones available." To do this job, the shop quoted me $3K in labor alone - an engine out job. Because I'm a stubborn cuss (and really like this car), I decided to do some trial and error replacement repairs. First, replaced the forward ignition control module (controls cylinders 1-3-5). The car ran perfectly - for about five minutes. The misfire returned. Next, replaced the cam position sensor. No change, no help. Test drive showed the car misfiring up to about 3k rpm, when full power would kick in for unknown reasons. Next, I spliced in a set of ignition coil connector housings (they'd all been removed and discarded in the first shop visit). Test started the car after each two connectors. No change after installing the first two, again no change after installing the second pair. After installing the last two, the car would not start. Last chance, Hail Mary, I replaced the crank position sensor. No change. At this point, the car cranks but will not run. If you get it running properly, it's a really decent car. I've put thousands into it over the years replacing struts, shocks, a complete front end rebuild, etc. When it was running, it was smooth and stable at 70mph. It didn't wander or pull, the brakes worked fine, and the tires have about 50% tread left. As you can see, the paint is toast and the interior is decent. The A/C doesn't work, you should know. If recharged it works fine, but only when it wants to. I'm told it could be a module behind the passenger side dash panel (best case scenario) or more likely the bellows are broken, which live deep inside the dashboard (worst case scenario). I just rolled down the windows and lived with it. Seems likely the misfire/no-start is either in the wiring harness as the shop suggested, or the ECU (computer) has failed. Either way, I'm done with it. I was thinking it was worth $750 when it ran poorly. Now that it doesn't run, $500 seems about right. It will need to be towed or trailered. Not interested in selling parts. The whole car or nothing. Phone number listed is a landline and doesn't receive texts.
- Price
- $500 USD
- Mileage
- 198,500 miles
- Fuel
- gas
- Transmission
- automatic
- Body type
- Wagon
- Condition
- fair
Photos
Buy directly from the owner on Carsido Marketplace. Listing located in Charlotte, NC.












