2001 Ford Ranger XLT 2dr 4x2 Super Cab Styleside 6 ft. box 125.7 in. WB Manual for sale in Newport, OR
Listed at $7,500 USD.
For sale is this 2001 3.0 Vulcan 2x4 Extended Cab Ford Ranger, 165K, $7,500 Almost all of the parts used were either OEM Motorcraft or a good aftermarket equivalent when at all possible: -- Extensive maintenance work done -- Low miles -- Great Engine, Transmission and frame -- Almost zero rust anywhere, even under the bed cover -- Consistently get 19-21mpg combined -- Clean Title In Hand -- Still good tread on tires, they were new when I got it -- Can get more pictures if desired -- Have Carfax report from before I got it Please do not ask me to provide a paid VIN report from some random website that has been in existence for only 3 months, I know your game and I know it's a scam. As with all Rangers it punches well above it's weight and has served me well doing tons of light-duty work and small trailer towing. Peppy, good compression. Yes I am aware it's only a 2x4 but it's the Vulcan engine. You cannot destroy these things even if you tried: non-interference, bare-minimum timing chain setup, and the camshaft synchronizer is right on the top of the engine, so thats the tradeoff. Paint isn't great, slight body damage, mechanically and structurally excellent condition. Very little rust anywhere, mostly on the bottom of the front subframe, but far from structural. -- Complete cooling system overhaul with new radiator, fan clutch, water pump, thermostat/housing and sensors; changed radiator fluid again in August -- Complete suspension rebuild: new upper/lower control arms, front rotors/pads/bearings, rear drums/shoes/bearings, coil and leaf springs (all Made in USA, with new rear shackles), shocks, new brake fluid, sway bar bushings, and Energy Suspension poly body mounts -- New spark plugs, wires and distributor -- All new door weatherstripping and sealing for the cab -- New idler and tensioner pulleys with new belt -- New Camshaft Synchronizer (properly oiled from the top down) -- New EVAP things that were expensive -- New windshield -- New light housings all around and new headlight bulbs -- New wiper motor -- New heater fan relay -- New PCV valve -- New transmission mount -- New fuel filter (pretty sure it had the original one when I got it . . .) -- Fixed driver window motor -- Fixed mirror motors -- Fixed some weird roof damage that didn't damage the structure but was LADEN with Bondo and had bad paint and some rust spots, not sure what that was all about but it seems good the past two years -- Changed all the fluids and put in a new transmission filter with a Felpro gasket, also new transmission mount -- Many Short interval oil changes and only used Mobil 1 Full to just flush the engine; I dont think it needed it, I just did it to be safe, changed oil again in July using Valvoline Restore And Protect -- Any hardware that was replaced is Grade 8 -- Ran a fuel system cleaner after I got it and fuel additive through it at least every other tank -- I greased every load bearing joint or contact point with either bearing or white lithium grease Also added that comes with the truck: -- New Uniden CB Radio installation and JVC radio done at Audio 101 who are experts at aftermarket sound stuff -- New Curt Class 3 hitch receiver with a three-ball hitch and 2" drop/2" Ball hitch that you can have -- A front/rear dash cam setup that's not super fancy, I just kind of threw it in because I don't trust people -- New bed rails from Summit Performance because it had a camper shell and the bare bed rails looked silly -- Also a new camper shell if you want it; it needs work, but the shell itself is fine and it functions well -- You'll get all the paperwork from everything I did or bought for the truck, including a printed packet that lists the torque specification for every single bolt on the entire truck There are some things I planned to do and have the parts for, but have not gotten around to just yet because I have been busy with work (you can just take the parts if you buy the truck, I wont need them after all): -- Oxygen sensors (they do go bad eventually, though I dont think these ones are; I tried changing them but they refuse to budge with me under the truck and unable to get any leverage, probably need a lift) -- Motor mounts (Anchor brand, the ones it has still seem fine though) -- I have a bunch of gaskets for intake, heads and exhaust that I planned to do just because I'm like that, they're all Felpro Made In USA so they're good quality -- Have a few new spark plugs, oil filters and another fuel filter you can have since none of our other cars take them It isn't perfect and has some minor quirks: -- The Speedometer is like 4-5mph fast for some reason, and is consistent through the speed range -- When I took the bed off to do the leaf springs I noticed the frame has a very slight bend inward on the back passenger side; it wasn't super noticeable but looking down the rails back to back you can definitely see it; though it does not cause any issues, it does give the truck a perennial Ranger Lean despite the all-new suspension components, which annoys me -- It still has an evap leak because why wouldn't it -- It consequently also has a constant P0442, but thats the only code it's thrown since I have had it besides a brief misfire that was fixed with the new distributor -- I took out the back seats because what madman would shove someone back there if not trying to torture them, I dont even think kids fit in those things, I used it for tools and supplies -- The dome light cover is missing; the light still works fine, but it costs like $150 for the cover and I didn't feel like it was that necessary -- The doors close a little snug, but considering I got it with minor unexplained passenger-side roof damage and all the weatherstripping was messed up, I guess thats an ok trade-off -- The back passenger door handle cable will sometimes pop out when trying to open it, which is annoying but not hard to set back in -- I have the spare tire but the rim is very rusty and the tire is shot -- It has a slight oil leak, but it's not catastrophic (I only seem to lose about a quart every 3k miles, which it might just be burning); I figured if it's the pan or the rear main, the motor mounts could be done at the same time since it's an engine-lift procedure -- Some of the dash lights are out, but you can still see the important stuff TL;DR --- I originally intended to keep it indefinitely as I liked it so much and found it so useful, but plans have changed and now I have a big beautiful truck I can do everything with, and feel I may benefit from selling the Ranger, even if I dont really want to. Mostly just want someone to take care of it because I love this truck. Message/text me if you want more pictures or have questions pertaining to anything not already mentioned.
- Price
- $7,500 USD
- Mileage
- 166,000 miles
- Fuel
- gas
- Transmission
- automatic
- Drivetrain
- rwd
- Body type
- Truck
- Condition
- excellent
Buy directly from the owner on Carsido Marketplace. Listing located in Newport, OR.








