2005 Scion TC Base for sale in Chattanooga, TN
Listed at $5,999 USD.
Selling my turbo sleeper Scion tC, it's built for 500hp by previous owner. I got a brand new Mustang in 2024 and I just dont drive the Scion much now. I've also since turned it down to around 350hp. Clear coat is peeling. You can see videos and more pics of the car here: https://www.showacar.com/scion No test drive without cash in my hand. I'll give you a ride if you want though, but I'm done with about pooing my pants for some of y'all's driving. Haltech Elite ECU Carrillo Rods Race Rod Bearings CP 9:1 Pistons Upgraded Retainers Upgraded Head Gasket ARP Head Studs 1000cc FIC Injectors TNX-40/60 Turbo, Dual Ball Bearing ACT Clutch with Fidanza Lightweight Flywheel Turbonetics RG45 Wastegate 1 Bar Turbonetics Godzilla BOV HT-061010 Haltech Gauge AEM Oil Pressure Gauge AEM Boost Gauge Raptor Shift Light in vent Custom Intake Manifold Custom Stainless Exhaust Manifold Custom Baffled Oilpan Custom 3 inch tig welded exhaust with Magnaflow muffler Willwood Big Break Kit Driveshaft Shop Axels Most lines including oil and vacuum Stainless Braided Walbro 255lph Fuel Pump Aeromotive Fuel Pressure Regulator Tein Coilovers HID and Euro Style Tail Conversion 2 Sony 12's and Sony Amp DDX374BT Car has a clean title, AC, Heat, and runs on 93 pump gas. The clear coat is peeling on the hood, trunk, and bumper, so those pics are the clear coat peeling not clouds. There's also a small dent in the hood which you can see in the pictures. I believe it also needs an alignment as it starts to shake around the 40 to 60 mph range. I did daily the car for about a year after I got her, but when the clutch went out, I couldn't afford to fix her at that time in my life so she sat for a couple years. She's been sitting again so she does need tires as they've started to crack from sitting in the sun. If you're driving far, you'll probably want to tow it back. Other than that if you're not constantly beating on the car, she's a pretty good daily. Obviously the more you're in it the more likely things are to break. It's usually little things like a fitting, a coupler, ect. The battery has been relocated to the trunk by previous owner, which means there's no spare tire, but I have two spare rims with drag slicks on it, though the slicks should probably be replaced as I've not used them since I got the car. The trunk lift plate is made of plastic and breaks if you actually use it to lift from, which I've learned the hard way. It's lost a couple clips so it's held on by epoxy, I have another lift plate that is reinforced with metal so it can be used to lift the trunk, unlike the factory plates, but it needs to be painted. It has a killswitch so the car cannot be started without pressing the button along with the key being in the ignition. The previous owner also bypassed the clutch position sensor so it can start without the clutch depressed as he had a remote start system, but he took it out before he sold it. The only documentation about the build is in the images. It doesn't specify what they installed, but the previous owner said it was built for 500hp and told me he had the shop install Carrillo rods, race rod bearings, CP 9:1 pistons, upgraded retainers, an upgraded head gasket, and ARP head studs. I have not been able to verify that these parts were installed, but I ran the car on the 400hp tune for 20,000 of about the 30,000 miles I've had the car and considering stock can only handle around 300hp, I trust what he said, but I can't guarantee it. I also have two transmissions one of which supposedly has a Quaife differential in it according to the previous owner. The transmission is the weak link, I turned it down to around 350hp because 400 horsepower is how the other two broke. If you want to push 400hp or greater you will need a better transmission or be prepared to replace it. I believe the E351 fits and can handle up to 500hp. If you buy the car you can have the broken transmissions if you want them. Turbo and clutch were replaced about 20,000 miles ago. The exhaust header was replaced by the tuner because the collector broke a weld out at the dyno, but I do still have it. It does not have the header wrap anymore. The last engine bay pic is most recent. The previous owner designed a lot of the kit. The oil pan is custom, has baffles, and increases the engine capacity to 6 quarts of oil. I run 6 quarts of Royal Purple (36130-6PK HPS 10W-30). The drain plug is flush mounted on the bottom of the oil pan and uses an allen key. I also have a spare dash if you decide you want to go pillar mounts for the gauges as there are holes in the current dash for the gauge mounts.
- Price
- $5,999 USD
- Mileage
- 60,166 miles
- Fuel
- gas
- Transmission
- manual
- Drivetrain
- fwd
- Body type
- Hatchback
- VIN
- JTKDE177150041541
Photos
Buy directly from the owner on Carsido Marketplace. Listing located in Chattanooga, TN.

















